BMW G310 R/GS Forum banner

1 - 12 of 12 Posts

Registered
Joined
32 Posts
Discussion Starter #1
I love everything about this bike except the hideous fender and at least here in the US, the stock indicators are obnoxiously long. So, I decided to clean it up with an R&G Tail Tidy, as well as a pair of MotoGadget mini indicators. The install was a breeze and the setup is super clean. All can be found on Revzilla. Photos below, including what the bike in Pearl White looks like with the decals removed should you prefer that look.
 

Attachments

Registered
Joined
8 Posts
I love everything about this bike except the hideous fender and at least here in the US, the stock indicators are obnoxiously long. So, I decided to clean it up with an R&G Tail Tidy, as well as a pair of MotoGadget mini indicators. The install was a breeze and the setup is super clean. All can be found on Revzilla. Photos below, including what the bike in Pearl White looks like with the decals removed should you prefer that look.
Very nice and neat.
 

Registered
Joined
32 Posts
Discussion Starter #6
Nope, nothing cut from the liner. The tail tidy comes with everything you need to replace the body work that you need to remove from the tail. The only thing I had to cut from the original bike was the wiring, but the indicators and tail light setups both came with bullet connectors so it was really easy.
 

Registered
Joined
32 Posts
Discussion Starter #7 (Edited)
The new tail lights are actually brighter than stock. They are amazing little things. You really can鈥檛 look at them directly too close or they鈥檒l hurt your eyes. I鈥檓 going to get a second pair for the front, for sure. 100% recommend them.
 

Registered
Joined
103 Posts
Nope, nothing cut from the liner. The tail tidy comes with everything you need to replace the body work that you need to remove from the tail. The only thing I had to cut from the original bike was the wiring, but the indicators and tail light setups both came with bullet connectors so it was really easy.
Thank you! That was the only thing that was stopping me because I couldn鈥檛 find any info on it. I just ordered mine!
 

Registered
Joined
29 Posts
@nhbmw

THANK YOU! This is *exactly* what I was thinking of doing - tail tidy and motogadget turn signals. So you said that the turn signals did not need any additional wiring? Did you have to put in resistors? Did it come with resistors? Or do they run fine without any?
 

Registered
Joined
32 Posts
Discussion Starter #10
The indicators came with inline resistors so I didn鈥檛 need to modify anything to set the correct blink rate. They just correctly blink out of the box. No other wiring or computer reset needed. Pretty spiffy!
 
1 - 12 of 12 Posts
Top